Short license plate holder incl. license plate light for Aprilia RS 660 20- / Tuono 660 21-

The HIGHSIDER AKRON-RS license plate holder is designed to perfectly match the lines of your Aprilia RS 660 or Tuono 660.

The model-specific bracket of the AKRON-RS enables mounting on the original mounting points of your bike and thus replacement without further drilling or cutting.
To prevent damage to cables, all sharp-edged feed-throughs are protected by a rubber membrane grommet.

The license plate is made of sheet steel and is 2 mm thick. It is precisely cut to size using a laser. After edging, a weather-resistant black powder coating is applied.
This ensures optimum fit and durability.
Thanks to the infinitely variable adjustment option, you can place the panel in the desired position without drilling. There is an additional locking screw to hold the plate in this position.

The width of the AKRON-RS blinker brackets can be adjusted and are therefore suitable for all types of accessory indicators. This adjustment option allows you to adapt the position of your indicators to a wide variety of license plates. The 10 mm holes are slotted to the side to allow the indicators to be fitted without disconnecting them from the wiring harness.

You can also individually adjust the position of the rear reflector using a slider. Adaptation to the different versions of EU license plates is therefore no problem.

Two rubber washers are included to securely screw the license plate and reduce vibrations. A further rubber buffer supports the license plate on its underside.

Details:
- Model-specific bracket
- Infinitely adjustable blinker holder
- slotted blinker holder for easy mounting without cable separation
- infinitely adjustable reflector, E-approved
- Suitable for European license plates
- Infinitely adjustable angle of inclination
- Additional screw for optimum positional security
- Simple fixing without further work steps (e.g. drilling)
- Simple mounting of the license plate using slotted holes

The scope of delivery of the AKRON-RS includes
- Model-specific bracket with mounting parts
- AKRON-RS license plate mounting plate
- Adjustable blinker brackets
- E-approved reflector with adjustable holder
- Fitting instructions

Notes:
- A special blinker holder is optionally available for the original indicators in the Accessories tab.
- If side reflectors are fitted to your original license plate holder, these must be refitted in a suitable position or replaced with new ones.

Tips:
If you have not found a model-specific license plate holder for your vehicle, the universal license plate holders from HIGHSIDER, which are available in many different designs, are certainly a good alternative.