HIGHSIDER Pro Apollo LED blinker module housing black / lens smoke gray (pair), front & rear
Article number:
BI-1107907
Manufacturer:
Highsider
Description
Product information
HIGHSIDER APOLLO MODUL LED blinker, E-approved for front and rear
LED blinker module suitable for installation or mounting, black aluminum ring with tinted glass. With this innovative lighting technology, 2 very bright SMD LEDs are installed in the center, enabling an extremely small design. The outer ring, on the other hand, consists of the new COB technology (Chip On Board). The new LED chip embedding for high-performance LEDs achieves a very high luminance with the best possible efficiency and service life. This also enables higher light values to be achieved than with conventional LEDs. This module is supplied with a black anodized aluminium ring that fits over the base body.
In the right direction - with the innovative blinker series from HIGHSIDER. Show not only where you want to go, but also who you are. This is trend-setting design at its best.
Dimensions:
A1: 13 mm
A2: 9 mm
D1: 22 mm
D2: 20 mm
Threaded bolt: M8, length: 12 mm
Connections:
Black cable = ground (-)
Yellow cable = blinker (+)
Scope of delivery: 1 pair
Note:
The unit can be installed flat without the aluminum ring, so that only the lens is visible. A 20 mm hole must be drilled for this.
Alternatively, the unit can be mounted with the aluminum ring on a mounting plate on the vehicle, for example, see instructions.
LED blinker module suitable for installation or mounting, black aluminum ring with tinted glass. With this innovative lighting technology, 2 very bright SMD LEDs are installed in the center, enabling an extremely small design. The outer ring, on the other hand, consists of the new COB technology (Chip On Board). The new LED chip embedding for high-performance LEDs achieves a very high luminance with the best possible efficiency and service life. This also enables higher light values to be achieved than with conventional LEDs. This module is supplied with a black anodized aluminium ring that fits over the base body.
In the right direction - with the innovative blinker series from HIGHSIDER. Show not only where you want to go, but also who you are. This is trend-setting design at its best.
Dimensions:
A1: 13 mm
A2: 9 mm
D1: 22 mm
D2: 20 mm
Threaded bolt: M8, length: 12 mm
Connections:
Black cable = ground (-)
Yellow cable = blinker (+)
Scope of delivery: 1 pair
Note:
The unit can be installed flat without the aluminum ring, so that only the lens is visible. A 20 mm hole must be drilled for this.
Alternatively, the unit can be mounted with the aluminum ring on a mounting plate on the vehicle, for example, see instructions.
Manufacturer
Highsider
|
Paaschburg & Wunderlich GmbH |
Reviews 0
Login
No reviews found. Share your insights with others.